Hydraulic bottle jack, 2 t, lifting height 181-345 mm, into the formation. case// Denzel

• Stels hydraulic jack with a safety valve is designed to lift loads weighing up to 2 tons.

• The jack is an indispensable tool in a car service, often used during repair and construction work .

• The minimum lifting height of Stels jack is 18.1 cm (low lifting).

• The maximum height that the jack can reach can lift the load, is 34.5 cm.

• This height is sufficient to install a rigid support under the raised load and carry out repairs.

• The safety valve prevents the lifting of a load that exceeds the weight declared by the manufacturer.

• The jack is also equipped with a magnetic collector that eliminates the presence of chips in the cylinder oil, which significantly reduces the risk of jack breakage.

• Supplied in a handy plastic case.

ATTENTION!

• The jack is not intended for long-term support of the load either suspended or to move it.

• Before lifting, make sure the load is evenly distributed over the center of the jack's bearing surface.

• Weight the load to be lifted must not exceed the mass specified by the manufacturer.

• The jack must be placed on a horizontal, level and firm surface during operation.

• After lifting the load, it is necessary to use special stands to support it.

• It is forbidden to carry out any kind of work under the lifted load without supports supporting it.

• Please read the user manual before using the product.